Administering The Ipsis - Avaya S8500 Installing And Configuring

Translating the IPSIs

Administering the IPSIs

These steps enable the IPSI circuit packs and allow them to control the port networks.
1. Type change system-parameters ipserver-interface and press Enter.
change system-parameters ipserver-interface
SERVER INFORMATION
Secondary Control Subnet Address: 192. 11 . 13 .4*
OPTIONS
2. Verify that the Primary Control Subnet Address is correct.
The subnet address must match the most significant 3 octets (the first 3 groups of digits in
the subnet address) of the Server IP address.
An Asterisk (*) to the right of the Subnet Address field means that although a subnet
address is displayed, it is not the correct one; Avaya Communication Manager does not
have the subnet information. After verifying the displayed information, submit this form with
or without changes to update software with the correct subnet information.
!
CAUTION:
If the information displayed in the Subnet Address field is not correct, it must be
CAUTION:
changed on the media server. Use the Maintenance Web Interface; under Server
Configuration and Upgrades, click Configure Server to change the media server
configuration. Then return here to perform this step.
3. Set the Switch Identifier: field to the switch ID letter (A through J; A is the default setting).
4. Set the IPSI Control of Port Networks: field to enabled.
5. Press Enter to effect the change.
62 Installing and Configuring the Avaya S8500 Media Server
IP SERVER INTERFACE (IPSI) SYSTEM PARAMETERS
IPSI Host Name Prefix:
Primary Control Subnet Address: 172. 22.
Switch Identifier: A
IPSI Control of Port Networks: enabled
NOTE: * indicates data changed on the server
Page
0. 0*
1 of 1