Resetting The Ipsi - Avaya S8500 Installing And Configuring

3. If necessary, use the following commands to set the VLAN and diffserv parameters to the
recommended values shown.
Note:
Use Help to obtain syntax guidelines for these commands.
Note:
Enter set vlan priority 6
●
Enter set diffserv 46
●
Enter set vlan tag on
●
Enter set port negotiation 1 disable
●
Enter set port duplex 1 full
●
Enter set port speed 1 100
●
4. Enter show qos to check the administered values.
5. Enter quit to exit.
!
Important:
Ensure that the port settings on the Ethernet switches are set to the same values
Important:
as shown above in the set port commands.

Resetting the IPSI

The following steps resets the IPSI and ends the administration session.
1. Type reset and press Enter
Answer Y to the warning.
Note:
Resetting the IPSI terminates the administration session. If further administration
Note:
is required, start a new telnet session to the IPSI.
Note:
Control network settings (IP address, subnet mask, and gateway) become
Note:
effective when you exit the IPADMIN session.
2. Disconnect the laptop from the faceplate.
3. Check the LCD. Verify that it has an I P with a filled-in V showing at the bottom. (See
Figure 7: LED display showing that the IPSI has a static IP
Programming the IPSI circuit packs
address)
Issue 3.1 June 2005 73