7-8 Convenient Functions for Setup
This section describes the functions that can be used when setting inspection items.
Making Settings with Stored Images
With an FQ-CR1 Sensor, judgement parameters can be set by using the following images.
• Images saved in internal Sensor memory
• Image files in an SD card
Saving Image Data
• Temporarily Saving Images in the Sensor
The measured images can be temporarily saved inside the Sensor.
These images are held until the Sensor power supply is turned OFF.
[In/Out] [Log setting] [Image logging]
Setting Logging Parameters for Image Data: p. 99
• Saving Images in the Sensor to an SD Card
The images that are temporarily saved inside the Sensor can be saved to an SD card.
(Setup Mode) [Save to file] [Logging] Tab Page
1
Press [Logging image].
2
Select whether to save the most recently logged image or to save all of the data that is logged in the
Sensor.
Storage location
\sensor_name\LOGIMAGE
• Saving Images in an SD Card
The image data can be saved in the SD card each time measurements are performed.
(Run Mode) [Logging]
Logging All Data (File Logging): p. 96
Displaying Image Data
• Images Saved in Internal Sensor Memory
(Setup Mode)
• Image Files in a SD Card
(Setup Mode)
Arranging the Display - Displaying a Saved Image: p. 93
108
Convenient Functions for Setup
YYYY_MM_DD-HH_MM_SS.IFZ
Example: The following name would be used for files saved at 10:10:21 pm on March 10,
2010.
2010_03_10-22_10_21.IFZ
[Log]
[File]
File name
FQ User's Manual