Omron FQ-CR1 User Manual page 135

Note
The field separator is not output unless the data continues.
The following range of values can be output.
999,999,999.9999  Measured value  999,999,999.9999
If the measured value is lower than 999,999,999.9999, then 999,999,999.9999 is output.
If the measured value is higher than 999,999,999.9999, then 999,999,999.9999 is output.
The following values are output if JG (Judge) is set.
OK: 0
NG: 1
Note
Data that is output after measurement is output until the last data even after the measurement is finished. Data out-
put is not interrupted midway.
 When Output Format Is Binary
Set the numerical expression.
Select either fixed decimal or floating-point decimal.
 Output Format
<Measured value of data 0 × 1,000><Measured value of data 1 × 1,000>
4 bytes
The measurement data multiplied by 1,000 is output continuously at 4 bytes per data. Negative numbers are
output as two's complements.
Example: When Data 0 Is 256.324 and Data 1 Is 1.000.
$ 0 0 $ 0 3 $ E 9 $ 4 4
Data 0: 256324
(256.324 × 1000)
Note
Binary output does not use data separators, i.e., field separators or record separators. These separators are used
only for ASCII output.
The following range of values can be output.
2,147,483.648  Measured value  2,147,483.647
If the measured value is lower than 2,147,483.648, then 2,147,483.648 is output.
If the measured value is higher than 2,147,483.648, then 2,147,483.648 is output.
The following values are output if JG (Judge) is set.
0 ( 0  1000)
OK:
NG: 1000 (1  1000)
Note
Data that is output after measurement is output until the last data even after the measurement is finished. Data out-
put is not interrupted midway.
FQ User's Manual
4 bytes
$ F F $ F F $ F C $ 1 8
−
Data 1: 1000
A delimiter will
(−1.000 × 1000)
be attached to
the end.
<Measured value of data 7 × 1,000>
· · ·
4 bytes
$ 0 D
Outputting/Controlling with Ethernet
CR
Delimiter
133