Omron FQ-CR1 User Manual page 117

• I/O Signal Allocations
Signal
Output signals OUT0 (OR signal)
OUT1 (BUSY signal)
Input signals TRIG
Important
The BUSY signal will remain ON while the measurement is being executed.
Performing Continuous Measurements
Continuous measurements are performed while the continuous measurement command is input from an
external device.
Immediately after a measurement is performed, the next measurement is performed.
This is repeated while a continuous measurement command is input with the IN0 to IN5 signals.
PLC
Note
This function can be used only when the input mode is set to Expanded Mode.
Wiring
Color Signal
Gray IN0
Green IN1
Red IN2
White IN3
Purple IN4
Yellow IN5
Black OUT0 (OR)
Orange OUT1 (BUSY)
FQ User's Manual
Address
CIO 0.00
CIO 0.01
CIO 1.00
(1) IN5 signal ON (IN0 to IN4 are OFF)
Or other
device
State Description
OFF Command parameters for continu-
ous measurements
OFF
OFF
OFF
OFF
ON Command input for continuous
measurements
-- Overall judgement (default assign-
ment)
-- Processing in progress (default
assignment)
(2) Performs continuous
measurements
The signals shown at the left
are used.
Refer to the following informa-
tion for signal wiring.
Wiring: p. 26
Controlling/Outputting in Parallel
115