Table of Contents
Advertisement
Checking Versions
• Checking the Sensor Version
(Setup Mode) [Sensor settings] [Information]
• Checking the Touch Finder Version
(Setup Mode or Run Mode) [TF settings] [Information]
Checking the Touch Finder Battery Level
(Setup Mode or Run Mode) [TF settings] [Battery level]
Important
• The battery level is displayed only for a Touch Finder with a DC/AC/battery power supply (FQ-D31).
• The settings will be lost if the battery runs out while you are making the settings. If the battery level is low,
save the settings and charge the battery immediately.
Changing the Sensor Name
An alphanumeric name can be assigned to a Sensor to make it easier to recognize. This is convenient when
more than one Sensor is connected.
(Setup Mode) [Sensor settings] [Information] [ ] [Rename]
Checking Available Memory in the Sensor
If a setting cannot be made, check the amount of memory that is available in the Sensor.
(Setup Mode) [Sensor settings] [Information] [ ] [Memory State]
Correcting the Touch Screen Positions of the Touch Finder
Use this function to correct the touch screen positions if they are offset from the opposite position.
(Setup Mode) [TF settings] [Touch screen calib]
Setting the Resolution of Measurement Objects Displayed on the PC Tool
Use this function to set the resolution of measurement object that are displayed on the Touch Finder on the PC.
(Run Mode) [TF settings] [Resolution]
110
Functions Related to the System
FQ User's Manual
Advertisement
Table of Contents
Troubleshooting
