Omron FQ-CR1 User Manual page 107

Removing an SD Card from the Touch Finder
1
Open the cover to the SD card slot on the top of the
Touch Finder.
2
Press in on the SD card until you hear a click.
3
Pull out the SD card.
4
Close the cover to the SD card slot.
• Never remove the SD card while data is being saved or read. The data on the SD card may be corrupted.
Important
Do not restart or turn OFF the power supply to the Sensor or Touch Finder while a message is being displayed
saying that data is being saved to or read from the SD card. The settings or system data may be corrupted.
Checking the Available Space on the SD Card
Before saving data to the SD card, use the following display to make sure that there is sufficient space available
on the SD card.
(Setup Mode or Run Mode)  [TF settings]  [SD card]  [SD card information]
The following information in the SD card inserted in the Touch
Finder can be checked.
Formatting an SD Card
(Setup Mode or Run Mode)  [TF settings]  [SD card]  [Format]
Press [Yes] to start formatting.
FQ User's Manual
105
SD Card Operations