Installation notes:
Install the new rubber tires with the surface texture turning in the direction as shown.
Note: Feel each rubber surface to verify it turns properly in the direction shown.
Printhead removal
Remove the scanner assembly.
1.
2.
Remove the top cover. See
Disconnect the cables.
3.
4.
Remove the printhead cable toroid (A) from the flat cable.
Note: Tuck the printhead cable toroid as shown below when reinstalling. Failure to do so can damage the
RIP board.
See"Flatbed removal" on page
"Top cover assembly removal" on page
4-75.
4-9.
A
Repair information
7525-63x
Previous
Next
Go Back
4-61