Lexmark X548 Series Service Manual page 59

Service error messages
Error code
109.02 Service
Black Printhead
109.03 Service
Black Printhead
109.04 Service
Black Printhead
109.05 Service
Black Printhead
109.08 Service
Black Printhead
109.11Service
Black Printhead
109.12 Service
Black Printhead
109.13 Service
Black Printhead
122.xx Service
Fuser Error
122.01 Service
Fuser Error
122.02 Service
Fuser Error
122.03 Service
Fuser Error
122.04 Service
Fuser Error
122.05 Service
Fuser Error
122.06 Service
Fuser Error
930.09 Service
LVPS
122.10 Service
Fuser Error
122.11 Service
Fuser Error
122.12 Service
Fuser Error
Description
The black printhead failed to complete
servo.
The black printhead mirror motors
failed to achieve lock.
The black printhead mirror motors lost
PLL motor lock.
Failure reading NVRAM from printhead
The black laser showed bad in EMS
testing.
Failure writing data to printhead
Failure reading data from the printhead
Printhead declared error.
Fuser error
EWC error—Attempting to print with
estimated power at or below minimum
power.
Fuser over temperature.
Fuser open thermistor check failed.
EWC Error—Did not reach EWC start
temperature in time.
EWC Error—Did not change
temperature within expected time.
EWC Error—Did not reach EWC stop
temperature in time.
Fuser zero crossings out of range.
Zero crossing detected.
Fuser failed to warm up.
Fuser under temperature error while in
standby.
Fuser under temperature error while
printing.
Action
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-54.
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-54.
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-54.
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-54.
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-54.
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-54.
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-54.
Perform a POR. If the problem persists, go
to
"Printhead service check" on
page 2-54.
Go to
"Fuser service check" on
page 2-38.
Go to
"Fuser service check" on
page 2-38.
Go to
"Fuser service check" on
page 2-38.
Go to
"Fuser service check" on
page 2-38.
Go to
"Fuser service check" on
page 2-38
Go to
"Fuser service check" on
page 2-38
Go to
"Fuser service check" on
page 2-38
Go to
"Fuser service check" on
page 2-38.
Go to
"Fuser service check" on
page 2-38.
Go to
"Fuser service check" on
page 2-38.
Go to
"Fuser service check" on
page 2-38.
Diagnostic information
7525-63x
Previous
Next
Go Back
2-15