Usb Connector Removal - Lexmark X548 Series Service Manual

7525-63x
Remove the backing from the new plate, and place the plate on the surface between the sensor mounting
4.
posts.
5. Connect the cable to the tray present sensor.
Replace the spring.
6.

USB connector removal

Remove the rear shield. See
1.
2. Disconnect the USB connector from the RIP board.
Remove the flatbed assembly. See
3.
Note: Do not remove the flatbed covers, or any of the hinges. The flatbed needs to be removed from the
print engine only.
4. Remove the operator panel from the flatbed assembly. See
page 4-102.
Remove the CCD ribbon cable cover (A), and route the USB cable out through the cable channel on the
5.
flatbed unit.
Service Manual
4-72
"Rear shield removal" on page
"Flatbed removal" on page
A
4-7.
4-75.
"Operator panel assembly removal" on
Previous
Next
Go Back