Power and electrical specifications
The following table specifies nominal average power requirements for the base printer configurations. All power
levels are shown in Watts (W). Maximum current is given in Amperes (A).
Printing states
Off
Sleep state
Ready state
Simplex printing
Duplex printing
Copying
ADF scanning
Typical electricity consumption test
Maximum (ave.) current while printing:
100–110 V
115–127 V
220–240 V
Low-voltage models
100–127 V (100–110 Japan) at 50–60 Hz, nominal
•
90–137 V (90–110 Japan), extreme
•
100-volt models
•
100 V ac at 47–63 Hz nominal
90–110 V ac, extreme
•
High-voltage models
220–240 V ac at 50–60 Hz nominal (not available in all countries)
•
198–259 V ac, extreme
•
Notes:
•
Using a 220 V ac to 110 V ac power converter with a low voltage printer is not recommended.
Using an inverter to change DC to AC voltage (12 V to 120 V for example) is not recommended.
•
All X54x MFP models will comply with the ENERGY STAR.
•
All models ship with Power Saver Mode = On.
•
The default timeout to Power Saver = 60 minutes (220 V).
•
•
Power Saver can be adjusted to 1–240 minutes.
Power Saver mode cannot be disabled from the operator panel.
•
0.2 W
23 W
50 W
540 W
380 W
530 W
60 W
5.13 kWh/week
8.2 A
7.2 A
3.6 A
7525-63x
General information
1-7
Previous
Next
Go Back