PRINT TESTS
Input source tests
The purpose of the diagnostic PRINT TESTS is to verify that the printer can print on media from each of the
installed input options. The contents of the Print Test Page vary depending on the media installed in the selected
input source.
Check each Test Page from each source to assist in print quality and paper-feed problems.
To run the Print Test Page:
1.
Navigate to PRINT TESTS.
Select the media source to test.
2.
Select Single or Continuous.
3.
If Single is selected, a single page is printed.
•
If Continuous is selected, printing continues until
•
If a source is selected that contains envelopes, an envelope test pattern is printed. If Continuous is
selected, the test pattern is printed only on the first envelope.
Note: The Print Test Page always prints on one side of the paper, regardless of the duplex setting.
Touch Back to return to PRINT TESTS.
4.
is pressed to cancel the test.
Diagnostic aids
7525-63x
Previous
Next
Go Back
3-15