Autocompensator mechanism (ACM)—standard tray removal
Remove the toner bottles, the waste toner bottle, and the imaging unit (IU). See
1.
removal" on page 4-63
Remove the rear shield. See
2.
Remove the left cover. See
3.
Remove the right cover. See
4.
5.
Disconnect the ACM cable connector JSP1 (A) from the RIP board.
Unclip the cable (B) from the retainers (C) on the left side.
6.
Reinstall the rear shield to protect the RIP board. Turn the printer so the bottom is facing you.
7.
Carefully tilt the printer so the rear shield rests on the table.
8.
and
"Waste toner bottle removal" on page
"Rear shield removal" on page
"Left cover removal" on page
"Right cover removal" on page
"Imaging unit (IU)
4-73.
4-7.
4-4.
4-7.
Repair information
7525-63x
Previous
Next
Go Back
4-13