HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual page 225

For example, to assign the E1 or T1 interface all the channels, enter:
ProCurve(config-e1 1/1)# tdm-group 1 timeslots 1-31
or
ProCurve(config-t1 1/1)# tdm-group 1 timeslots 1-24
7. Configure the line coding. For E1 interfaces, use the following syntax:
Syntax: coding [ami | hdb3]
ProCurve(config-e1 1/1)# coding ami
HDB3 is the default setting for E1 interfaces.
For T1 interfaces, use the following syntax:
Syntax: coding [ami | b8zs]
ProCurve(config-t1 1/1)# coding ami
B8ZS is the default setting for T1 interfaces.
8. Configure the frame format for the E1- or T1-carrier line. For E1-carrier
lines, use the following syntax:
Syntax: framing crc4
If your public carrier is using E1 framing format, do not enter a framing
command. E1 framing is the default setting for E1 interfaces. If your PTT
is using CRC4, change the frame format.
ProCurve(config-e1 1/1)# framing crc4
If you need to change the frame format back to E1, enter:
ProCurve(config-e1 1/1)# no framing crc4
For T1 interfaces, use the following syntax to configure the framing:
Syntax: framing [d4 | esf]
ProCurve(config-t1 1/1)# framing d4
The default setting for T1 framing is ESF.
9. Configure the clock source setting.
Syntax: clock source [internal | line | through]
ProCurve(config-e1 1/1)# clock source line
or
ProCurve(config-t1 1/1)# clock source line
Configuring E1 and T1 Interfaces
Quick Start
4-39