HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual page 473

Secure router procurve 7000dl series

Hide thumbs Also See for ProCurve Secure 7000dl Series:

Table of Contents

Set the LDN. (If your public carrier has assigned you a SPID, skip this

step and go to the next step.) Otherwise, enter:

Syntax: isdn ldn1 <number>

Replace <number> with the LDN phone number assigned to the

ISDN line you are configuring. For example, you might enter:

ProCurve(config-bri 1/1)# isdn ldn1 5555551212

d. Set the SPID and LDN. If your public carrier has assigned you a SPID,

you should set the SPID and the LDN at the same time. Enter:

Syntax: isdn spid1 <number> <ldn1>

For example, you might enter:

ProCurve(config-bri 1/1)# isdn spid1 12355512120101 5551212

Activate the interface. Enter:

ProCurve(config-bri 1/1)# no shutdown

Configure an ISDN group.

Create an ISDN group by enter the following command from the

global configuration mode context:

Syntax: isdn-group <number>

Replace <number> with a number between 1 and 255 to uniquely

identify this ISDN group.

b. Assign a BRI interface to the ISDN group. Enter:

Syntax: connect bri <slot>/<port>

Replace <slot> and <port> with the numbers that identify where the

BRI interface is installed. You can assign multiple BRI interfaces to

the ISDN group. For example, you might enter:

ProCurve(config-isdn-group 1)# connect bri 2/1

ProCurve(config-isdn-group 1)# connect bri 2/2

Assign the ISDN group to a resource pool. From the ISDN group

configuration mode context, enter:

Syntax: resource pool-member <poolname>

For example, if the resource pool is called Branch, enter:

ProCurve(config-isdn-group 1)# resource pool-member Branch

The ISDN group can be a member of only one resource pool.

Configuring Demand Routing for Primary ISDN Modules

Chapters

Table of Contents