HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual page 469

Setting
isdn spid1 <number> <ldn1>
isdn spid2 <number> <ldn2>
connect-sequence <sequence-number>
dial-string <string> [<resource-type>]
[busyout-threshold <value>]
ip route <destination A.B.C.D> <subnet
mask | /prefix length> <next hop A.B.C.D
| forwarding interface ID>
Description
specifies the telephone number and
identifiers for each TE on the line; used for
ISDN BRI U modules
specifies:
• number to call to establish a
connection (dial-string <string>)
• type of connection to establish
(<resource-type>—ISDN 64 Kbps or
ISDN 56 Kbps)
• number of times to call the number if
a connection cannot be made
(busyout-threshold <value>)
specifies the route to the far-end network
1. Enter the global configuration mode context:
ProCurve> en
Password:
ProCurve# configure terminal
2. Create an access control list (ACL) to define the interesting traffic.
a. From the global configuration mode context, enter:
Syntax: ip access-list [standard |extended] <listname>
For example, you might enter:
ProCurve(config)# ip access-list extended Call
b. From the ACL configuration mode context, configure permit or deny
entries. Enter:
Syntax: [permit | deny] <protocol> <source address> <source port>
<destination address> <destination port> [log | log-input]
Replace <protocol> with one of the following:
– AHP
– ESP
– GRE
– ICMP
– IP
– TCP
– UDP
Configuring Demand Routing for Primary ISDN Modules
Quick Start
Your Setting
8-77