Configuring The Data Link Layer Protocol For - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

Using the Web Browser Interface for Basic Configuration Tasks
Configuring the Data Link Layer Protocol for E1, T1, and Serial Interfaces
C a u t i o n
14-46
Status Information
Status information is displayed at the bottom of the Configuration for Serial
window. This readout is not in real-time. To update the readout to the current
statistics, click the Continuous Refresh button. To end continuous refresh,
click the Stop Refreshing button. To reset the statistics, click the Clear
Statistics button.
Figure 14-33. Status for Serial Interface
Clicking the Continuous Refresh button requires the router to send continuous
updates, consuming bandwidth and router resources.
Configuring the Data Link Layer
Protocol for E1, T1, and Serial Interfaces
This section explains how to configure the Data Link Layer protocol for an
E1, T1, or Serial interface. You should configure the physical interface to use
the same Data Link Layer protocol that your public carrier is using:
For PPP, see "Configure PPP as the Data Link Layer Protocol" below.
For Frame Relay, see "Configure Frame Relay as the Data Link Layer
Protocol" on page 14-52.
For HDLC, see "Configure HDLC as the Data Link Layer Protocol" on page
14-58.
If you need additional information about any of the options, see Chapter 6:
Configuring the Data Link Layer Protocol for E1, T1, and Serial Interfaces.