Setting The Mtu For Demand Interfaces - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

Configuring Demand Routing for Primary ISDN Modules
Using Demand Routing for ISDN Connections
data-call authentication protocol pap
data-call sent authentication protocol pap
!
interface bri 2/1
isdn ldn1 968483940096
no shutdown
!
interface bri 2/2
isdn ldn1 978484540055
no shutdown
!
interface demand 1
idle-timeout 240
resource pool Pool
match-interesting list Call out
match-interesting reverse list Call in
connect-sequence 1 dial-string 9633333 forced-isdn-64k busyout-threshold 3
connect-sequence 2 dial-string 9634444 forced-isdn-64k busyout-threshold 3
connect-sequence interface-recovery retry-interval 120 max-retries 0
ip address 10.1.1.1
ppp authentication pap
ppp multilink
ppp multilink maximum 2
username procurve password procurve
ppp pap sent-username procurve password procurve
no shutdown
!
!
isdn-group 1
min-channels 4
max-channels 4
resource pool-member Pool
connect bri 2/1
connect bri 2/2
!
ip access-list extended Call
permit ip any 192.168.2.0 0.0.0.255
!
ip route 192.168.2.0 255.255.255.0 demand 1
8-56
255.255.255.0
Figure 8-15. Using PAP Authentication with Demand Routing

Setting the MTU for Demand Interfaces

When establishing a link, PPP peers must agree on how much data can be
contained in the information field of PPP frames. The value that communi-
cates this frame size is called the maximum receive unit (MRU). To increase
data-call commands to
enable PAP authentication
PAP configured for this demand interface
username and password that the demand
interface expects to receive from its PPP peer
username and password that the demand
interface sends to its PPP peer