Quick Start; Configure The Physical Layer: The Adsl Interface - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

Secure router procurve 7000dl series

Hide thumbs Also See for ProCurve Secure 7000dl Series:

Table of Contents

ADSL WAN Connections

Quick Start

This section provides the commands you will need to quickly configure an

Asymmetric Digital Subscriber Line (ADSL) WAN connection on the ProCurve

Secure Router. Only a minimal explanation is provided.

If you need additional information about any of these options, see "Contents"

on page 7-1 to locate the section and page number that contains the explana-

tion you need.

Before you begin to configure the ADSL interface, you should know the

settings that you must enter for the following:

signal-to-noise ratio (SNR) margin

training mode

Your service provider should tell you the settings you need to enter.

To configure the ADSL interface, complete these steps:

Use ribbon cabling with RJ-11 connectors to connect the ADSL port on

the ProCurve Secure Router to the wall jack provided by your service

Establish a terminal console session or Telnet session with the ProCurve

Secure Router.

Move to the enable mode context. If you have configured a password for

the enable mode context, enter that password when you are prompted to

ProCurve> enable

Move to the global configuration mode context.

ProCurve# configure terminal

Table of Contents