HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual page 694

Using the Web Browser Interface for Basic Configuration Tasks
ISDN Modules
14-72
Figure 14-53. Configuration for a BRI Interface
3. Enter a description in the Description box if you want to document
information about the BRI interface. This information will be displayed in
the running-config under the appropriate interface heading.
4. To activate the interface, select the Enable box.
5. If you want the BRI interface to replace the caller ID of incoming calls
with a different number, select the Caller Id Override box. Enter the
number that replaces incoming numbers in the Override Number field.
6. Select the ISDN signaling used by your service provider from the Switch-
Type pull-down menu.
7. Enter the local directory number (LDN) for the ISDN line in the LDN1
field.
8. If your service provider has assigned this line a secondary LDN, enter it
in the LDN2 field.
9. In North America, service providers assign ISDN lines Service Profile
Identifiers (SPIDs). Enter your line's primary SPID in the SPID1 field. If
the line has been assigned a secondary SPID, enter it in the SPID2 field.
10. Click Apply.
ISDN connections on the ProCurve Secure Router use demand routing for the
Data Link Layer. You must configure demand routing from the CLI.