Software Overview; Bootup Process - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

Secure router procurve 7000dl series

Hide thumbs Also See for ProCurve Secure 7000dl Series:

Table of Contents

Software Overview

Software Overview

To manage your ProCurve Secure Router, you must understand basic router

operations, including how the router uses:

Secure Router OS (SROS) boot code

SROS software

the startup-config

the running-config

Further, you must understand how the Secure Router OS is organized so that

you can properly configure the router and enable safeguards to protect the

router from unauthorized access.

This section describes software operations such as the boot process, the

process of saving configurations, the OS hierarchy, and the bootstrap mode.

Concurrent with the release of J02_02A.biz software in July 2005, ProCurve

Networking changed the boot process for the ProCurve Secure Router. By

default, the ProCurve Secure Router now boots from compact flash. If a

compact flash card is not inserted into the compact flash slot or if the card

does not contain the required Secure Router OS file, the router will boot from

internal flash. Previously, the ProCurve Secure Router booted only from

internal flash.

This change has been made in routers that shipped after July 2005; these

routers have the following serial numbers:

ProCurve Secure Router 7102dl (J8752A) US525TRAP4 or later

ProCurve Secure Router 7203dl (J8753A) US522TS252 or later

If you purchased a ProCurve Secure Router before this change was made, you

can enable the new boot process by upgrading to J02_02A.biz or later and

making a small configuration change. For information about this configura-

tion change, see Appendix A: Configuring the Router to Boot from Compact

Table of Contents