Configuring Ppp Authentication For An Isdn Connection - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

interface bri 2/1
isdn ldn1 968483940096
no shutdown
!
interface bri 2/2
isdn ldn1 978484540055
no shutdown
!
interface demand 1
idle-timeout 240
resource pool Pool
match-interesting list Call out
match-interesting reverse list Call in
connect-sequence 1 dial-string 9633333 forced-isdn-64k busyout-threshold 3
connect-sequence 2 dial-string 9634444 forced-isdn-64k busyout-threshold 3
connect-sequence interface-recovery retry-interval 120 max-retries 0
ip address 10.1.1.1
ppp multilink
ppp multilink maximum 2
no shutdown
!
isdn-group 1
min-channels 4
max-channels 4
resource pool-member Pool
connect bri 2/1
connect bri 2/2
!
ip access-list extended Call
permit ip any 192.168.2.0 0.0.0.255
!
ip route 192.168.2.0 255.255.255.0 demand 1
N o t e
255.255.255.0
channels
Figure 8-14. MLPPP Configuration for Demand Routing
Configuring PPP Authentication for an ISDN
Connection
If you want to ensure that only authorized peers establish a PPP connection
with the demand interfaces on the ProCurve Secure Router, you can configure
PPP authentication. The ProCurve Secure Router supports Password Authen-
tication Protocol (PAP) and Challenge Handshake Authentication Protocol
(CHAP) for PPP authentication.
To protect your WAN, ProCurve Networking strongly recommends that you
enable PPP authentication for the ISDN connection.
Configuring Demand Routing for Primary ISDN Modules
Using Demand Routing for ISDN Connections
MLPPP enabled
8-53