Configure Frame Relay As The Data Link Layer Protocol - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

Using the Web Browser Interface for Basic Configuration Tasks
Configuring the Data Link Layer Protocol for E1, T1, and Serial Interfaces
14-52
Figure 14-37. Configuring the Local Router to Authenticate Itself
4. In the pull-down menu for Sent Authentication Type, select PAP or CHAP.
The protocol must match that requested by the peer. If you do not know
the protocol your peer is using, you will either have to contact the peer
or view PPP debug messages in the CLI. (See "PPP Authentication" on
page 6-11.)
5. Enter the local router's username and password in the Sent Username
and Sent Password fields. If you are using CHAP, you only have to enter
a username if it is different from the router's hostname.
6. Click Apply.

Configure Frame Relay as the Data Link Layer Protocol

The following steps explain the initial configuration of Frame Relay as the
Data Link Layer protocol. It is assumed that you have configured the Physical
Layer—the E1, T1, or serial interface—and you have selected Frame Relay as
the Data Link Layer protocol. As a result, the Frame Relay Configuration
window is displayed.