HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual page 480

Configuring the E1 + G.703 and T1 + DSX-1 Modules
Configuring the E1 + G.703 Module
N o t e
9-6
If you have not yet entered a bind command to join the physical interface to
the logical interface, the channel assignment will not be displayed correctly.
e1 1/1 is UP
Receiver has no alarms
E1 coding is HDB3, framing is E1
Clock source is line
No network loopbacks
Last clearing of counters never
loss of frame
loss of signal : 0
AIS alarm
Remote alarm
Timeslot Status: 01234567890123456789012345678901
Status Legend: '-' = Timeslot is unallocated
'N' = Timeslot is dedicated (nailed)
'D' = Timeslot is allocated to G703 drop port
'F' = Timeslot is dedicated for framing
Line Status: -- No Alarms --
5 minute input rate 120 bits/sec, 0 packets/sec
5 minute output rate 120 bits/sec, 0 packets/sec
Current Performance Statistics:
0 Errored Seconds, 0 Bursty Errored Seconds
0 Severely Errored Seconds, 0 Severely Errored Frame Seconds
0 Unavailable Seconds, 0 Path Code Violations
0 Line Code Violations, 0 Controlled Slip Seconds
0 Line Errored Seconds, 0 Degraded Minutes
TDM group 1, line protocol is UP
Encapsulation PPP (ppp 1)
74 packets input, 4622 bytes, 0 no buffer
0 runts, 0 giants, 0 throttles
66 input errors, 24 CRC, 42 frame
0 abort, 0 discards, 0 overruns
127 packets output, 5554 bytes, 0 underruns
Figure 9-1. Viewing the Channel Assignments for the E1 and G.703 Interfaces
After you ensure that the channel assignments are correct, you will need to
configure the settings for the G.703 interface.
: 0
: 0
: 0
FNNNNNNNNNNNNNNNDDDDDDDDDDDDDDDD
Channels 1-15 are "nailed" to
the E1 interface.
Channels 16-31 are allocated
to the G.703 interface.