Using the Web Browser Interface for Basic Configuration Tasks
Configuring ADSL Interfaces
14-66
•
OAM PVC Frequency—determines the time delay between OAM
loopback cells. This setting is used unless the router is verifying a PVC
state change (in which case it uses the OAM retry frequency setting).
Specify a number between 0 to 600 seconds. The default setting is 1
second.
23. Select the encapsulation setting that your ADSL service provider is using:
•
aalsnap
•
aalmux ip
•
aalmux ppp
24. Click Apply to save your settings to the startup-config.
If you are configuring just ATM as the Data Link Layer protocol, continue with
"Configuring ATM Only" on page 14-66. If you are configuring PPPoE or
PPPoA, you must configure a PPP interface. See "Configuring PPPoE or
PPPoA for the ADSL Connection" on page 14-68.
Configuring ATM Only
25. After you select IP routing, a new section called IP Settings, is displayed.
Figure 14-50.IP Settings Section