Using the Web Browser Interface for Basic Configuration Tasks
Configuring Ethernet Interfaces
14-36
Figure 14-26.PPPoE for the Ethernet Interface
6.
If you want to configure PPP authentication, see "PPP Authentication" on
page 14-50.
7.
Configure IP settings. For Address Type select one of the following.
•
None—Select this setting if you intend to set up a bridge group with
the PPP interface.
•
Static—Select this setting if you want to configure a static IP address.
The boxes to enter the IP address and subnet mask are displayed, so
that you can enter the appropriate address for the PPP interface.
•
Negotiated—Select this setting if you want the PPP interface to
negotiate an IP address from your service provider. Select Default
Route if you want to configure the interface to receive a default
gateway from the peer.
•
Unnumbered—To set up the PPP interface with the same IP address
as another interface, click the Unnumbered option. The Interface box
is displayed.
Use the pull-down menu for the Interface box to select the appropri-
ate interface. The menu will display any ATM subinterfaces, Frame-
Relay subinterfaces, HDLC interfaces, loopback interfaces, and PPP
interfaces that are already configured.