Serial Module For The Procurve Secure Router; Standards Supported By The Serial Module - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

Serial Module for the ProCurve Secure Router

The ProCurve Secure WAN serial modules are used when the public carrier
provides an external CSU/DSU for an E1- or T1-carrier line. (See Figure 5-2
on page 5-5.) ProCurve Networking offers two serial modules:
one-port narrow module
eight-port, or octal, wide module
If your company is the United States or Canada and your public carrier does
not provide an external CSU/DSU, you must purchase and use a T1 module.
If your company is in another country and the public carrier provides only
a CSU, you must purchase and use an E1 module. (For instructions on
configuring these modules, see Chapter 4: Configuring E1 and T1
Interfaces.)

Standards Supported by the Serial Module

The ProCurve Secure Router serial modules are standards based. Specifically,
they support the following standards:
U.S. Federal Communications Commission (FCC) Part 15 Class A
Norme Européenne EN55022 Class A—EN is also referred to as European
Standards.
EN55024, EN61000-3-2, EN61000-3-3
European Telecommunications Standards Institute (ETSI) TBR 1 and
ETSI TBR 2
EN60950
UL/CUL 60950
Australian Standard/New Zealand Standard (AS/NZS) 60950
International Electrotechnical Commission (IEC) 60950
International Organization for Standardization (ISO) 4903 (X.21)
Comité Consultatif International Téléphonique et Télégraphique
(CCITT) V.35 Synchronous (V.35)
Configuring Serial Interfaces for E1- and T1-Carrier Lines
Using the Serial Module for E1- or T1-Carrier Lines
5-7