HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual page 132

Controlling Management Access to the ProCurve Secure Router
Using the AAA Subsystem to Control Management Access
2-22
To end the banner, you must enter the same character that you used to signal
the beginning of the banner.
Configuring a Fail Message. A fail message is displayed if the user's
attempts to log in to the router and fails. By default, the fail message is:
Authentication Failed
To customize a fail message, move to the global configuration mode context
and enter the aaa authentication fail-message command followed by a
character that signals the beginning of the message that you want to display.
For example, you might enter the
ProCurve(config)# aaa authentication fail-message !
Then type the message you want to be displayed if a login attempt fails. After
entering the message, enter the same character you used to signal the begin-
ning of the fail message. In the example above, you would enter the
Configuring a Username or Password Prompt. By default, the ProCurve
Secure Router displays the following prompts to help users log in to the router:
Username:
Password:
To customize the username prompt, move to the global configuration mode
context and enter:
Syntax: aaa authentication username-prompt <prompt>
Replace <prompt> with the word you want displayed when users attempt to
log in. For example, if you want the prompt to be User, enter:
ProCurve(config)# aaa authentication username-prompt User
To customize the password prompt, move to the global configuration mode
context and enter:
Syntax: aaa authentication password-prompt <prompt>
Replace <prompt> with the word you want displayed when users attempt to
log in. For example, if you want the prompt to be Secret, enter:
ProCurve(config)# aaa authentication password-prompt Secret
character or even the
@
, as shown below:
!
character.
!