HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual page 655

Secure router procurve 7000dl series

Hide thumbs Also See for ProCurve Secure 7000dl Series:

Table of Contents

Figure 14-24.IP Settings Section

10. Use the pull-down menu to configure the Address Type:

None—Select this setting if you intend to set up a bridge group with

the Ethernet interface.

Static—Select this setting if you want to configure a static IP address.

The boxes to enter the IP address and subnet mask are displayed, so

that you can enter the appropriate address for the Ethernet interface.

DHCP—Select this setting to configure the interface as a Dynamic

Host Configuration Protocol (DHCP) client.

Unnumbered—To set up the Ethernet interface with the same IP

address as another interface, click the Unnumbered option. The

Interface box is displayed.

Use the pull-down menu for the Interface box to select the appropri-

ate interface. The menu will display any ATM subinterfaces, Frame-

Relay subinterfaces, HDLC interfaces, loopback interfaces, and PPP

interfaces that are already configured.

11. Configure dynamic DNS, if needed. For more information about dynamic

DNS, see "Configuring Dynamic DNS" on page 14-91.

For Dynamic DNS, use the pull-down menu to select DynDNS.org,

DynDNS.org Static, or DynDNS.org Custom. Choose the service for

which you registered with DynDNS.org. Additional boxes are dis-

played, allowing you to configure information about your account

with DynDNS.org.

Using the Web Browser Interface for Basic Configuration Tasks

Configuring Ethernet Interfaces

Chapters

Table of Contents