Vpn Express Wizard; Figure 33 Vpn Express Wizard: Step 2; Table 16 Vpn Express Wizard: Step 2 - ZyXEL Communications ZyWALL 1050 User Manual

ZyWALL 1050 User's Guide

4.7.1 VPN Express Wizard

Click the Express radio button as shown in
screen.

Figure 33 VPN Express Wizard: Step 2

The following table describes the labels in this screen.

Table 16 VPN Express Wizard: Step 2

LABEL
Name
Secure
Gateway
Pre-Shared Key Type your pre-shared key in this field. A pre-shared key identifies a communicating
Next
90
DESCRIPTION
Type the name used to identify this VPN connection (and VPN gateway). You may
use 1-31 alphanumeric characters, underscores(
character cannot be a number. This value is case-sensitive.
Enter the WAN IP address or domain name of the remote IPSec router (secure
gateway) to identify the remote IPSec router by its IP address or a domain name. Set
this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN IP address.
party during a phase 1 IKE negotiation. It is called "pre-shared" because you have to
share it with another party before you can communicate with them over a secure
connection.
Type from 8 to 31 case-sensitive ASCII characters or from 16 to 62 hexadecimal ("0-
9", "A-F") characters. Precede hexadecimal characters with "0x".
Both ends of the VPN tunnel must use the same pre-shared key. You will receive a
PYLD_MALFORMED (payload malformed) packet if the same pre-shared key is not
used on both ends.
Click Next to continue.
Figure 32 on page 89 to display the following
_ ), or dashes (-), but the first
Chapter 4 Wizard Setup