Figure 373 User/Group > Setting > Force User Authentication Policy > Add/Edit; Table 163 User/Group > Setting > Force User Authentication Policy > Add/Edit - ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1 User Manual

Chapter 34 User/Group
Table 162 User/Group > Setting (continued)
LABEL
Source
Destination
Authenticate
Add icon
34.4.1 Force User Authentication Policy Add/Edit
Use this screen to specify a condition when users must log in or do not have to log in to the
ZyWALL before their HTTP traffic can pass through the ZyWALL.
Figure 373 User/Group > Setting > Force User Authentication Policy > Add/Edit
The following table describes the labels in this screen.
Table 163 User/Group > Setting > Force User Authentication Policy > Add/Edit
LABEL
Enable
Description
508
DESCRIPTION
This field displays the source address object of traffic to which this condition
applies. It displays any if this condition applies to traffic from all source addresses.
This field displays the destination address object of traffic to which this condition
applies. It displays any if this condition applies to traffic from all destination
addresses.
This field displays whether users must log in (force) or whether users do not have
to log in (skip) when this condition is checked and satisfied.
This column provides icons to add, edit, move, and remove conditions. It also
provides icons to activate and deactivate conditions.
To add a condition, click the Add icon at the top of the column or next to each
condition. If you click the one at the top of the column, the new condition is first in
the list. If you click the one next to a condition, the new condition appears right
below this condition.
To edit a condition, click the Edit icon at the top of the column or next to each
condition. The Force User Authentication Policy Add/Edit screen appears.
To remove a condition, click on the Remove icon next to the condition. The web
configurator confirms that you want to delete the condition before doing so.
To move a condition up or down in the list, click on the Move to N icon next to the
condition, and type the line number (# field) where you want to move this condition.
The # field is updated accordingly.
To activate or deactivate a condition, click the Active icon next to the condition.
Make sure you click Apply to save and apply the change.
DESCRIPTION
Select this if you want this condition to be active.
Enter a description for this condition. It can be up to 60 printable ASCII characters
long.
ZyWALL 1050 User's Guide