Table of Contents
Advertisement
Invacare® Storm⁴ Series
10.
Press both catches (3) inwards and open battery box shroud.
11. Loosen and remove both screws (2).
12. Remove safety catch (1) and G-Trac bracket (3).
13. Loosen and remove self-locking nut (5).
14. Remove G-Trac sensor.
15. Disconnect cable of G-Trac sensor from power module.
16. Replace G-Trac sensor.
Installing G-Trac Sensor
1. Install parts in reverse order.
2. Connect all cable connectors to their former positions.
3. The G-Trac sensor must be installed with the cable pointing upwards. The module has a guide that must fit exactly into
the G-Trac sensor holder.
4. Test all functions.
6.9.5 Replacing Gyro plate
•
10 mm wrench
Removing Gyro plate
1. Remove rear shroud. See 6.8.1 Replacing Rear Shroud, page 55.
2. Loosen and remove locking nut C including washer.
3. Loosen and remove screws D.
4. Remove Gyro B and Gyro plate A.
5. Replace Gyro plate.
Installing Gyro plate
1. Install parts in reverse order.
6.9.6 Replacing actuator module under seat
The actuator module is optional.
Tools:
•
4 mm Allen key
62
Fig. 6-53
1533060-N
Advertisement
Table of Contents
