Replacing The Lifter / Tilt Module - Invacare Kite Service Manual

®
Invacare - Kite

8.15.3 Replacing the lifter / tilt module

ATTENTION: Danger of crushing!
The seat/seat support is very heavy. Danger of injury to hands and feet!
· Use proper lifting techniques
Requirements:
· 5 mm Allen key
· 6 mm Allen key
· 6 mm wrench
· Side cutting pliers
· Cable ties
Note
Take careful note of the exact position of the seat. Mark the position it is mounted in, the angle
and so on. If necessary, make photographs with a digital camera.
Any modification of the adjustment of the seat affects the centre of gravity of the wheelchair.
Uninstalling the lifter / tilt module:
·
If possible, raise the lifter to the highest position.
·
If possible, tip the wheelchair with the tilt module as far backwards as it will go.
·
Switch the electronic control system off.
·
Disconnect the plug at the height of the tilt actuator (1).
SERVICE MANUAL
93