Acs2 Remotes: Error Codes And Diagnostic Codes - Invacare Kite Service Manual

®
Invacare - Kite
6.2

ACS2 remotes: Error codes and diagnostic codes

The drive electronics can automatically rectify some faults. In this case the status display will stop
blinking. Switch the remote on and off again several times. Wait around 5 seconds each time
before switching the remote on again. If this does not rectify the fault, determine the cause using
the blink codes from the following table.
BLINK CODE
1 x blink
2 x blink
3 x blink
4 x blink
5 x blink
6 x blink
7 x blink
8 x blink
9 or 10 x blink
11 x blink
12 x blink
POSSIBLE CAUSE
Module defective
Accessory error (for
example short circuit in the
actuator)
Lifter too high or too low
(seat not at driving height)
Error in motor M1
Connection loose/faulty or
motor faulty
Error in motor M2
Connection loose/faulty or
motor faulty
Fault/brake fault in motor
M1. Connection loose or
faulty or motor faulty
Fault/brake fault in motor
M2. Connection loose or
faulty or motor faulty
Completely discharge
battery
Battery voltage too high
Faulty data transmission
between modules
Drive motors overloaded /
overheated
Compatibility problems
between modules
SOLUTION
Replace defective module
Check accessory
connections, check
accessory
If the lifter is raised, lower it
slowly until the status
display stops blinking. If the
lifter is too low, raise it
slowly until the status
display stops blinking. Only
drive when the seat is at
driving height.
Check connection plug,
check motor
Check connection plug,
check motor
Check connection plug,
check motor
Check connection plug,
check motor
Pre-charge battery
Switch lighting to low
battery voltage
Check battery charger
Remove electronic modules
except for the power
module and the remote.
Replace the modules one
after another in order to
ensure which was the one
causing the fault.
Switch remote on and off /
wait if necessary
Remove incorrect module
SERVICE MANUAL
DOCUMENTATION
See chapter 8.1.5.
See chapter 7.3.
See operating manual
See chapters 8.6 and
7.1
See chapters 8.6 and
7.1
See chapters 8.6 and
7.1
See chapters 8.6 and
7.1
See operating manual
See charging unit
operating manual
See chapter 8.1.5.
-
See chapter 8.1.5.
25