®
Invacare
- Kite
8.2.3
Replacing the G-Trac sensor
Requirements:
· 10 mm open-ended wrench
Uninstalling the G-Trac sensor:
·
Switch the electronics OFF on the remote.
·
Remove the rear cover, as described in chapter 8.1.1.
·
Take exact note of the positions of all cables and the sockets that they are connected to. Mark
the connectors and sockets or take a photograph with a digital camera.
·
Disconnect the plug (3) of the G-Trac sensor (1) from the power module. (2).
·
Loosen the M6 nut (4) and push the G-Trac sensor upwards.
·
Pull the G-Trac sensor backward and out.
·
Replace the G-Trac sensor.
Installing the G-Trac sensor:
·
Insert the square-end piece into the slot provided for this purpose.
·
When installing the G-Trac sensor, make sure it is positioned exactly vertical.
·
Reconnect all cable connectors to their former positions.
·
The last step is to test all functions of the vehicle.
SERVICE MANUAL
39