Replacing The Lifter / Seat Angle Adjustment Module - Invacare Pronto M41 Series Service Manual

®
Invacare - PRONTO M41
8.9.2.4

Replacing the lifter / seat angle adjustment module

Note
Replacement of the seat angle adjustment module is performed in the same manner.
CAUTION: Risk of crushing!
The seat is very heavy. Risk of injury to hands and feet!
• Use proper lifting techniques
Requirements:
● 3 mm Allen key
● 5 mm Allen key
● T25 Torx wrench
● T40 Torx wrench
● Side cutting pliers
● Cable ties
• Remove legrests.
• Tilt the seat angle adjustment completely to the
rear if possible.
• Switch the electronics OFF on the remote.
• Remove the backrest cushion.
• Loosen and remove the screws, which secure
the middle seat plate (A) with a 3 mm Allen key.
• Remove the middle seat plate (B).
• Loosen and remove the screws on both sides,
which secure the lateral seat plates (C) with a
3 mm Allen key.
• Remove the lateral seat plates (D).
or
• Remove the seat cushion.
• Loosen and remove the screws on both sides,
which secure the sling seat (A) with a
T25 Torx wrench.
• Remove the sling seat (B).
SERVICE MANUAL
71