Invacare Kite Service Manual page 94

SERVICE MANUAL
·
Open the power supply chain of the lifter:
- Flip the cover (1) up.
- Pull the flap (2) out of the cover.
- Repeat this procedure link by link.
·
Remove both cable ties that secure the cable at the ends of the power supply chain.
·
Pull the cable out of the power supply chain.
·
Use the Phillips screwdriver to loosen the screws (1).
·
Remove the power supply chain (2).
·
Use the Phillips screwdriver to loosen the screws (4).
·
Additionally the sensor (5) is secured with nuts.
Loosen the nuts while holding a 6 mm wrench against.
·
Remove the magnet (3).
·
Remove the sensor (5).
94
®
Invacare - Kite