Replacing The Tilt Module - Invacare Kite Service Manual

®
Invacare - Kite

8.15.2 Replacing the tilt module

ATTENTION: Danger of crushing!
The seat/seat support is very heavy. Danger of injury to hands and feet!
· Use proper lifting techniques
Requirements:
· 10 mm Allen wrench
· 13 mm open-ended wrench
· 24 mm open-ended wrench
· 24 mm box wrench
· Side cutting pliers
· Cable ties
·
Remove the legrests.
·
If possible, tilt the seat back as far as it will go.
·
Switch the electronics OFF on the remote.
·
Remove the rear and the middle covers, as described in chapter 8.1.1 und 8.1.2.
·
Take exact note of the positions of all cables and the sockets that they are connected to. Mark
the connectors and sockets or take a photograph with a digital camera.
·
Disconnect the plug (1) of the actuator to be tested from the actuator module.
·
Pull the actuator cable out of the wheelchair. If necessary, also remove the cable ties.
SERVICE MANUAL
91