Adjusting The Flex3 Backrest - Invacare Kite Service Manual

®
Invacare - Kite

8.19.3 Adjusting the Flex3 backrest

Requirements:
· Phillips screwdriver
· 5 mm Allen key
·
Remove the front lateral plates (2 and 4) from the backrest (1) by loosening and removing the
five hexagon socket head screws (3).
·
Remove both Phillips screws (A) on the middle plate.
·
Shift the position of the rear plate halves (three settings are possible using the drill holes).
- Before pulling the Flex3 backrest apart, a "1" will be visible in the
small, rectangular cut-out.
- After pulling the Flex3 backrest apart, a "2" will be visible in the
small, rectangular cut-out.
·
Re-insert the two screws (A) into the middle plate.
·
Fasten the front lateral plates (2 and 4) again.
SERVICE MANUAL
115