Replacing The Rear Light Completely (Led Lighting Unit) - Invacare Kite Service Manual

®
Invacare - Kite
8.7.3

Replacing the rear light completely (LED lighting unit)

Note
Replacing an individual LED is not possible. If there is a defect, replace the entire rear light.
Uninstalling the tail light:
·
Switch the electronics OFF on the remote.
·
Remove the rear cover, as described in chapter 8.1.1.
·
Press the clips of the tail light lens (1) together slightly
·
Pull the tail light lens carefully off of the rear cover (4).
·
Disconnect the plug of the tail light (2) and of the turn signal (3) from the tail light cable (5).
·
Press the clips of the tail light lens or the turn signal together slightly.
·
Pull the corresponding light towards the rear and out of the rear cover.
·
Replace the faulty part.
Installing the tail light:
·
Re-assembly is done in reverse order.
·
Pay attention to markings on the plugs of the tail light cable, of the tail light and of the turn
signal.
·
Test all functions of the vehicle.
SERVICE MANUAL
55