20° Adjusting The Seat Angle Flex2 Seat Or Modulite Seat - Invacare Kite Service Manual

®
Invacare - Kite
10.2.2 20° Adjusting the seat angle Flex2 seat or Modulite seat
Requirements:
· 5 mm Allen wrench
· Screwdriver, flat, width approx. 6 mm
· Small hammer
ATTENTION: Danger of crushing!
The seat is very heavy. Danger of injury to hands and feet!
· Use proper lifting techniques.
Overview of the fixation points, depending on desired seat height:
Seat
height
in cm
46
48
50
Adjusting the actuator holder on the chassis
Detailed instructions on the actuator can be found in
chapter 8.15.1.
·
Use the screwdriver to remove the SL-retainer (1)
of the lower holding bolt.
·
Place a support under the seat.
·
Pull the holding bolt.
·
Adjust the actuator with holding bolt to the desired
height, according to the above table.
·
Secure the holding bolt with the SL-retainer.
20° tilt with Flex2 seat
B C
X
X
Actuator holder
D b
X
X
SERVICE MANUAL
c d
X
X
131