SERVICE MANUAL
8.2.4
Replacing the lighting circuit board
Requirements:
· 8 mm open-ended wrench
· Phillips screwdriver, size 2
Uninstalling the lighting circuit board:
·
Switch the electronics OFF on the remote.
·
Remove the rear cover, as described in chapter 8.1.1.
·
Take exact note of the positions of all cables and the sockets that they are connected to. Mark
the connectors and sockets or take a photograph with a digital camera.
·
Disconnect the plug (2) from the lighting circuit board (1).
·
Loosen and remove both screws on the lighting circuit board (3).
·
Replace the lighting circuit board.
Installing the lighting circuit board:
·
Assemble the parts in reverse order.
·
Reconnect all cable connectors to their former positions.
·
The last step is to test all functions of the vehicle.
40
®
Invacare
- Kite