SERVICE MANUAL
9
Installing accessories
9.1
Replacing the holding strap
Requirements:
· open-ended spanner, 13 mm
· 5 mm Allen key
Note
A nut is fixed between the two washers (2) and (4) as a spacer so that the belt mounting can
rotate freely.
·
Remove the plastic cap (5).
·
Loosen the bolt (3) and the associated nut
(in the figure this is covered by the plastic
cap) with a 5 mm Allen key and a 13 mm
socket spanner.
·
Remove the nut.
·
Remove the bolt including safety belt and flat
washers (2) and (4).
·
Remove the flat washers (4).
·
Replace the safety belt (1).
·
Refit the parts in the reverse order.
116
®
Invacare
- Kite