Ic Cards - Ricoh A193 Service Manual

5. IC CARDS

5.1 INSTALLATION PROCEDURE

CAUTION
Before installing an optional unit, perform the following:
1. Print out all messages stored in the memory.
2. Print out the lists of user-programmed items and the system
parameter list.
3. Switch off the main and ac switches, and disconnect the power cord
and telephone cable.
4. Once a Function Upgrade Card has been installed, do not remove it. If
removed, this will result in data being permanently lost.
Lithium Battery
The function upgrade card contains a lithium battery. The danger of
explosion exists if a battery of this type is incorrectly replaced.
Replace only with same or an equivalent type recommended by the
manufacturer. Discard used batteries in accordance with the
manufacturer's instructions.
1. Remove the IC card slot cover from the
left side cover.
2. Function Upgrade Card only:
Install a lithium battery into the IC card.
(Refer to the IC card instruction manual.)
Then turn on the battery switch on the IC
card.
3. Install the card, with the painted face on
the left, into the appropriate slot, as
shown.
4. Replace the IC card slot cover.
5. Turn on the machine's ac and main
switches, then press the 'Facsimile' key.
(A639) 3-13
IC CARDS
A194i513.img
S A F M e m o r y C a r d 2 M / 4 M
or
HDD Interface
F u n c t i o n U p g r a d e C a r d
or
D a t a C o p y T o o l
P a g e M e m o r y C a r d
A194i514.wmf
SM