Ricoh A193 Service Manual page 1015

Rev. 04/2000
A193 ROM MODIFICATION HISTORY
DESCRIPTION OF MODIFICATION
- A blank sheet is printed out when the start
key is pressed if the memory is full and the
scanning restarted after printing the
scanned image and then the first original
jammed.
- Toner scattering around the black image
on the rear side in the duplex mode. The
default of the separation output voltage
was changed.
SP2-901-1© -1800
SP2-901-2© -1800
SP2-901-3© - 2500
SP2-901-4© - 2500
- When the RAM was cleared by SP5-801,
the white level and the standard white
plate density at the factory were erased.
- Paper jam when paper is fed from the 3rd
tray immediately after feeding the paper
from the 4th tray.(A jam or Y jam) with the
following papers.
- 3rd Tray has the paper less than 288mm
length (A4 )
- 4th Tray has the paper 289mm to 401mm
length (A4 )
- If when the duplex copy is made with
ADF, Duplex Unit and 12M Memory and
the original is jammed, only the jammed
original cannot be copied correctly at
recovery copy.
SM
(Copier Section)
SERIAL
FIRMWARE
NUMBER
LEVEL
A1935532J January '97
A1935532K February '97
A1935532L March '97
A1935532M May '97
6-15
ROM HISTORY
FIRMWARE
VERSION
1.36
1.38
1.43
1.48
(A193)