Software Upload (Function) - Ricoh A193 Service Manual

1.26 SOFTWARE UPLOAD (FUNCTION 16)
This procedure copies software from the FCU board inside the machine to an

external FCU.
CAUTION
If the machine has an optional Function Upgrade Card, change bit 7 of
the System Switch 1E to "1", before removing the card, or the
programmed data on the card may be lost.
Re-set the switch back to zero before step 11 below, otherwise the fax
unit will not start up without the card installed.
1. Turn off the machine's ac switch.
2. Remove the IC card guiderails ([A] and [B]) from the FCU.
3. Connect the target FCU [C] to the data copy tool [D], and make sure that
the switch [E] on the data copy tool [D] is off.
4. Remove the cover [F]. Insert the copy tool [D] in the lower left slot [G].
5. Turn on the machine's ac and main
switches, then enter fax service mode.
 
6. Press

7. Press then
If the software has been successfully
uploaded, the display shows 'OK'.
Otherwise, the display shows 'NG'.
(A639)
[A]
[G]
[B]
A194M552.wmf

4-15
SERVICE LEVEL FUNCTIONS
[D]
[E]
[C]
A194M554.wmf
A194M530.img
A194M539.img
[F]
SM