Connecting A Synapse Cable Interface; Configuring Your Scanner; Removing The Interface Cable - Motorola Symbol LS9208 Product Reference Manual

Connecting a Synapse Cable Interface

NOTE See the Synapse Interface Guide provided with the Synapse cable for detailed setup instructions.
Symbol's Synapse Smart Cables enable interfacing to a variety of hosts. The appropriate Synapse cable has the
built-in intelligence to detect the connected host.
To host
Synapse Smart Cable
Synapse Cable Connection
Figure 1-3
Plug the Synapse adapter cable (p/n
1.
Interface Cable on page
Align the 'S' on the Synapse adapter cable with the 'S' on the Synapse Smart Cable and plug the cable in.
2.
Connect the other end of the Synapse Smart Cable to the host.
3.

Configuring Your Scanner

To configure the scanner: use the bar codes included in this manual, or use the 123Scan
See Chapter 4, User Preferences
Chapter 10, 123Scan2
The scanner supports RS-232, IBM 468X/469X, Keyboard Wedge, Wand Emulation, USB, and Synapse to
interface to a host system. Each host-specific chapter describes how to set up these connections.

Removing the Interface Cable

To remove the interface cable:
Unplug the installed cable's modular connector by depressing the connector clip and gently pulling back.
1.
Follow the steps for
2.
25-32463-xx)
1-2.
for information about programming the scanner using bar code menus. See
to configure the scanner using 123Scan
Installing the Interface Cable on page 1-2
Synapse adapter cable
To scanner
into the bottom of the scanner, as described in
2
. The program includes a help file.
to connect a new cable.
Getting Started 1 - 5
Installing the
2
configuration program.