Replacing The Steel Bearer, Tube Guide, Cr Tape Power Cable And Ink Tube - MUTOH Falcon II Outdoor Maintenance Manual

4.6.7. Replacing the steel bearer, tube guide, CR tape power cable and ink tube

Notes :
Step 1 :
Remove the 8 screws fixing the CR cover.
1 = CR cover
Step 2 :
Remove the CR tape power cable connector from the CR board assembly and Mainboard assembly.
Step 3 :
Remove the 2 screws fixing cable push plate.
To replace the board and connect or disconnect the FFC type cable, you should
leave the plug disconnected from the power socket for a while. Otherwise, over-
current could be generated and damage board.
Remove following covers before replacing the steel bearer, tube guide, CR tape
power cable, and ink tube.
Side cover R: refer to "Removing side cover R"
Side cover L: refer to "Removing side cover L"
Front cover: refer to "Removing the front cover"
Carriage cover: refer to "Removing the carriage cover"
Y rail cover: refer to "Removing the Y rail cover"
Falcon II Outdoor series printers – Maintenance Manual
2 = Screws (M3x8) fixing the CR cover
100 AP-74065, Rev. 1.0, 21/11/03