MUTOH Falcon II Outdoor Maintenance Manual page 282

5 [ ] Near End
6 [ ] Ink End
7 Not Original
Ink
been set to the up (2) Check the
position. P_REAR sensor
assembly for the
contact condition.
(3) The Mainboard
may be damaged.
The remaining (1) Check the ink
amount of ink is low. end via
Printing is still "Test:Sensor" of
possible. the self-diagnostic
function.
There is no more ink
left. Printing in
progress is
interrupted
immediately.
(2) Check the ink
sensor connector
for the contact
conditions.
(1) Check the ink
end ID via
"Test:Sensor" of
the self-diagnostic
function. (This is
limited to when
smart chips are
set.)
Falcon II Outdoor series printers – Maintenance Manual
•Redo the
connections of
Mainboard
assembly
connectors J128
and J129. If the
paper is not
initialized, the
sensor may be
damaged.
• Replace the
P_REAR sensor
assembly.
• Replace the
Mainboard
assembly.
• Operate the lever
at the end
detecting element
of the ink sensor
assembly to check
if the ink end
indication
changes. (At this
time, the sensor
for detecting the
presence of
cartridges is set to
Yes.)
If there is no
response, replace
the ink sensor
assembly.
• Redo the
connections of the
following
connectors.
• Junction board :
J401 – J418
• Mainboard : J133
– J134
• If the type of the
installed cartridge
does not match the
displayed type, the
ink ID sensor may
be damaged.
282
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
→ Replacing the
P_REAR_R
sensor assembly
and P_REAR_L
sensor assembly.
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
→ Sensor menu
→ Replacing the
I/H (ink holder)
assembly
→ Replacing the
Junction board
assembly.
→ Sensor menu
AP-74065, Rev. 1.0, 21/11/03