Connecting The Printer Power Cable - MUTOH Viper TX Operation Instructions Manual

3.6.3 Connecting the printer power cable

•
Make sure that the enclosed power cable is used. Use of a different cable may result in electric
shock or fire.
•
Do not use a damaged power cable. Doing so may result in electric shock or fire.
•
The disconnect device is the plug on the power supply cord.
•
Do not attempt to plug in electrical plugs with wet hands. Doing so may result in electrical
shock.
•
Be sure to use the specified voltage (AC 100V-120V/220V-240V). Otherwise, electrical shock or
fire may occur.
•
Use electricity directly from a power outlet (AC 100V-120V/220V-240V). Do not put many loads
on one electrical output. Otherwise, heat may be generated and cause fire.
•
Be sure to use an outlet with an earth terminal, and use the terminal correctly. Otherwise,
electrical shock or fire may occur.
•
Do not connect earth cables in the following areas :
o
o
o
•
Follow the instructions below when handling the power plug. Otherwise, fire may occur.
o
o
•
Ensure that the plug has been disconnected from the power socket when it is not used for a
long time.
•
Earth wires must be connected to wires or terminals that fulfil the conditions :
o
o
•
Be careful of the following when handling the power cable.
o
o
o
o
Downloaded From ManualsPrinter.com Manuals
Important
Important
Gas pipes. Doing so may cause fire or an explosion.
Earth terminals for telephone lines or lightning rods. Doing so may cause a large
flow of voltage if lightning occurs.
Water pipes or faucets. If there is a plastic part in the pipe, the earthing will not work
correctly.
Caution
Wipe away dust and any other residue before inserting the plug.
Ensure that the plug is firmly inserted as far as it will go.
Earth terminals of power socket
Earth wires with copper morsel that is at least 650 mm under ground
Caution
Do not make any modifications to the power cable.
Do not place anything heavy on the power cable.
Do not bend, twist, or pull the cable.
Do not wire the cable near equipment that generates heat.
Viper TX – Operation Instructions
44
AP-75710, Rev. 1.1, 09/01/2008